Vmware Virtual Centre services do not start automatically after reboot

VMware VirtualCenter service does not start automatically after reboot

Purpose

In some cases a race condition can occur when the VirtualCenter Server service starts before the SQL database service it depends on is started.

This article provides steps to prevent the race condition from occurring. Resolution This issue may occur if the VirtualCenter Server service starts before one of the services it depends on is started. The VirtualCenter Server service is dependent on the following services:

   * SQL Services
   * ADAM Services (when using linked mode in vCenter Server 4.0)

To resolve this issue, add a dependency to the VirtualCenter service so that it starts only after the necessary services have started.

Resolution

Note: This solution assumes that the database server and the SQL server reside on the same machine. If the SQL server is on a different physical machine, you must ensure that the SQL server is functioning before attempting to start the VirtualCenter service.

To create a service dependency:

  1. Click Start > Run.
  2. Type services.msc and press Enter.
  3. Locate any services that VirtualCenter requires. For example, SQLEXP_VIM or ADAM_VCMSDS.
  4. Open the service properties and note the service name. For example, MSSQL$SQLEXP_VIM .
  5. In the Run dialog, type regedit.exe and press Enter. Browse to HKEY_LOCAL_MACHINE\SYSTEM\CurrentControlSet\Services\vpxd.
  6. Double-click the DependOnService key and add the Service name using the name identified in step 4.
  7. Close Regedit.
  8. Go back to the Services window and open the service properties for the service identified in step 3.
  9. On the Dependencies tab,verify the VMware VirtualCenter service is listed as depending on the service.
 10. Repeat steps 3 to 9 for any services that VirtualCenter requires.

If you are running Windows 2008 you can set the VMware VirtualCenter Server service to startup type Automatic (Delay) as follows:

  1. Click Start > Run.
  2. Type services.msc and press Enter.
  3. Right-click on the VMware VirtualCenter Server service and click Properties.
  4. Change the startup type from Automatic to Automatic (Delay).

Leave a Reply

Your email address will not be published. Required fields are marked *